Filter
Top Products
3
107064
OWNER’S MANUAL
PRODUCT
IDENTIFICATION
Figure 1 - Log Base Assembly
LOCAL CODES
Install and use fireplace with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code, ANS Z223.1, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
UNPACKING
1. With utility knife, cut the carton all the
way around above the staples on the
bottom tray. Lift the carton off the
heater. Remove packing.
Note:
The
hood is located in the packing on the
right hand side of the heater front. Lift
the heater off the bottom tray.
2. Locate two screws above top corners
of the fireplace screen. Remove and
discard these screws. Lift fireplace
screen up and pull out to remove.
3. Remove protective packaging applied
to logs, log base assembly, and
fireplace.
4. Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought fireplace.
REMOTE CONTROL
ACCESSORIES
The optional remote controls that can be
purchased separately for this log heater are
hand held remotes. See Accessories, pages
24 and 25.
O
F
F
P
I
L
O
T
O
N
H
I
L
O
Log Set
Remote Selector
Switch (Optional)
Piezo Ignitor
Optional Remote Control
Control Knobs
Figure 2 - Fireplace
Top Louvered
Hood
Bottom Louver Assembly
Screen
Assembly
Top Outer
Casing
Firebox
Support
Rear Access
Door
SAFETY
INFORMATION
Continued
16. Operating fireplace above elevations of
4,500 feet could cause pilot outage.
17. To prevent performance problems, do
not use propane/LP fuel tanks of less
than 100 lbs. capacity.