Filter
Top Products
105501-01F
For more information, visit www.desatech.com
For more information, visit www.desatech.com
7
7
10. Attach stove door by inserting step bolt through door hinge
pivot hole and into threaded hole in stove body (see Figures 9
and 10, page 6). Use an adjustable wrench or a 12mm socket
to fasten step bolt. Tighten step bolt until snug. Make sure door
moves freely.
11. Install door catch bolt (M8 x 1.25-55mm with two M8 hex
nuts) into threaded hole on stove body (see Figure 9, page 6).
Use an adjustable wrench or a 12mm socket. The catch bolt
has two hex nuts attached to it (see Figure 13). The top nut is a
bolt stop and the bottom nut is for door leveling adjustment.
12. Check general catch bolt alignment with door claw. Make fi-
nal adjustment and door leveling after stove is in normal stand-
ing position.
13. Carefully lift stove back up on its four attached legs.
14. Set top grate into stove top.
CAST IRON STOVE AND
DIRECT-VENT BURNER
SYSTEM ASSEMBLY
Continued
CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY
Stove Body Assembly (Cont.)
Installing Direct-Vent Burner System Into Stove Body
INSTALLING DIRECT-VENT BURNER
SYSTEM INTO STOVE BODY
1. Carefully lift burner system and place into stove body from
the rear of stove.
2. Using screws provided, attach burner system to back of stove.
Figure 11 - Attaching Stove Bottom
Bottom Of
Stove Unit
Bolt
Washers
Stove Bottom
Figure 12 - Attaching Stove Door
Step Bolt
Door
Hinge
Threaded
Hole
Stove
Door
Stove Bottom
Bolt Shoulder
Figure 13 - Catch Bolt and Door Claw Orientation
Door Claw
Door
Adjusting Nut
Bolt Stop
Catch Bolt
Figure 14 - Installing Burner System Into Cast Iron Stove Body
L
O
H
I
P
I
L
O
T
O
F
F
O
N
Cast Iron
Stove Body
Burner
System
Screw