Filter
Top Products
14
100353
INSTALLING
HEATER
Continued
INSTALLING GLASS PANEL
1. Locate the glass panel package inside the back of the heater.
CAUTION
Before installing glass panels, inspect the edges. If you
notice any chips or cracks, do not install. If the surface
on either side is deeply scratched, do not install. If
these conditions exist, contact your Vanguard dealer for
replacement glass panels.
Figure 9 - Removing Lower Front Access Panel
Glass
Guard
Lower Front
Access Panel
CAUTION
Glass panels may have sharp edges. Handle with care.
CAUTION
Do not operate heater without glass panels installed.
Operating heater without glass panels will damage front
of heater due to excess temperatures.
2. Remove lower front access panel of heater by removing two screws at upper
corners of panel. The lower front access panel covers the lower front access
area (see Figure 9).
3. Remove two screws on glass guard. Remove glass guard (see Figure 9).
4. Carefully insert one glass panel up through lower front access area (see Figure 10,
page 15).
5. Carefully slip glass panel behind hearth assembly (see Figure 10, page 15).