Filter
Top Products
www.desatech.com
100448-01E2
5. Slide the adjustable outer-hood sections into the
center section. Stop when edge of center-hood
section is even with tape (see Figure 4).
6. Place pieces of tape across adjustable outer-
hood sections and center-hood section to hold
in place.
IMPORTANT: You must remove tape before
operating your fireplace.
INSTALLING HOOD TO MASONRY
FIREPLACE
Follow the instructions below that best describes
your fireplace.
Masonry With Glass Doors
1. Loosen clamps that hold glass door frame to
fireplace. Slide the mounting brackets behind
the glass door frame (see Figure 5). Place
brackets near ends of horizontal glass door
frame. Note: If frame is too tall, the bottom
of mounting bracket will not slide under lintel
(top) of fireplace. If so, cut mounting bracket
off at point "B" (see Figure 6). Slide mounting
bracket into glass door frame (see Figure 7).
2. Tighten glass door lintel clamps. This will
secure the mounting brackets.
3. Slide the hood over the mounting brackets (see
Figure 8).
Figure 4 - Adjust Outer-Hood Section
Edge of Center-
Hood Section
Masonry Without Glass Doors
1. Tape the mounting brackets near the ends of
the fireplace opening. Make sure to position
brackets as shown in Figure 9.
2. Mark screw locations on fireplace lintel
through the slots on bottom of each mounting
bracket.
Figure 5 - Placement of Mounting
Bracket
Glass
Door
Frame
Mounting
Bracket
B
A
Bottom of
Mounting
Bracket
Figure 6 - Mounting Bracket
Figure 8 - Hood Placement
Figure 9 - Positioning Brackets for
Masonry Fireplace without Glass Doors
Lintel
Masonry
Screw
Mounting
Bracket
Glass
Door
Frame
Mounting
Bracket
Hood
Mounting
Bracket
Figure 7 - Mounting Bracket Placement
For Tall Frame