Filter
Top Products
111162-01A
8
For more information, visit www.desatech.com
For more information, visit www.desatech.com
INSTALLATION
Continued
Figure 6 - Laying Down Stove On Side (Stove Style May Vary
Depending on Model)
Front of
Stove
Unit
Pallet
Wood
Bolted to
Stove
Body
Bottom
Top of Stove Unit
Front of
Stove Unit
Top of
Stove Unit
Drop
Cloth/
Blanket
Figure 7 - Removing Pallet Wood From The Bottom of The Stove
Pallet
Wood
Bolt
Pallet
Wood
Bottom Of
Stove Unit
Front
STOVE CAVITY ASSEMBLY
1. Lift off corrugated box enclosing stove body crating.
2. Remove all screws fastening the wood frame enclosure. Spread
wood frame open and lift away from plastic-bagged stove body.
The bottom pieces of pallet wood will remain bolted to the
stove body.
3. Remove plastic bag from stove body.
4. Remove back panel from stove (see Figure 5). Use an adjust-
able wrench or a 10 mm socket. Remove six (6) bolts and wash-
ers. Keep bolts and washers to reattach back panel later.
5. Remove all contents from inside stove cavity. Contents include:
(1) - Stove bottom
(4) - Legs (Amity™ and Townsend™ models include leg lev-
eler bolts)
(1) - Bottom door
(1) - Top grate
(1) - Hardware kit bag with fasteners
6. Carefully lay stove body on back to attach bottom components
to stove body (see Figure 6). Rest stove on drop cloth or blan-
ket to avoid scratching stove edges.
7. Remove remaining pallet wood attached to bottom of stove
body (see Figure 7). Use an adjustable wrench to remove bolts.
Figure 5 - Removing Back Panel
Bolt
Product
Identification
Label
Back Stove
Panel
Figure 8 - Locating Threaded Holes for Stove Bottom, Legs, and
Door Attachment (Appearance May Vary Depending on Model)
Amity™ and Townsend™ Models
8. Fasten each leg to stove with four (4) M8 x 1.25 - 20mm bolts.
Use a flat washer and lock washer with each bolt. Tighten bolts
into threaded holes on stove body (see Figures 8 and 9). Use
an adjustable wrench or a 12mm socket.
9. Fasten stove bottom to stove with four (4) M6 x 1 - 25mm
bolts. Use a flat washer and lock washer with each bolt. Tighten
bolts into threaded holes on stove body (see Figure 8 and Fig-
ure 10, page 9). Use an adjustable wrench or a 10mm socket.
Leg
Hole
Leg
Hole
Leg Hole
Leg Hole
Door Hinge Step
Bolt Hole
Door Catch Bolt
With Adjustable
Hex Nuts Hole
Holes for
Stove
Bottom
Front
Bottom Of
Stove Unit
Figure 9 - Attaching Stove Legs (Amity™ Model Shown)
Bottom Of
Stove Unit
Leg
Bolt
Washers
INSTALLATION
Stove Cavity Assembly