Filter
Top Products
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
10
7. Remove the four wing nuts
which hold the Wick
Assembly to the heater and
carefully lift the Wick
Assembly from the heater.
8. Replace the Wick Adjustment Knob temporarily.
Turn the Knob CLOCKWISE to raise the Wick.
9. While still holding the Wick
Assembly up-side-down, grasp
the Wick Cover firmly and
PULL it off with a sharp tug.
CAUTION :
The inside of Wick
cover has sharp teeth. The use
of work gloves is suggested to
avoid injury.
11. Reinstall a new wick and
insert the 3 pins on a new
Wick into the 3 holes on
the Wick Sleeve in the
upward direction.
(See the marked "
›flup"
on the Wick Sleeve.)
12. Push the new Wick into
the retainer teeth of the
Wick Sleeve so that the
wick adheres tightly
around the inside of the
Wick sleeve so that it is
not loose anywhere.
10. Remove the Wick while
folding it to the inside.
Remove the Wick Sleeve
together with the Wick.
13. While pressing each of the
three pins of the Wick
(attached to the Wick
sleeve) toward the inside,
insert the three Pins into
the slanted grooves of the
Wick Guide. Press on each
of the three pins, inserting
them securely in the holes.
NOTE : Be sure to check Wick height it should be 3/8” (10mm).
7/32 in. (5.5mm) All around
WICK 25/64 IN. (10 mm)
RIM OF
WICK
ADJUSTER
(holder)
14. The Wick height will automatically be set to the correct burning
height of 3/8" (10mm).
NOTE : Turn the Wick adjustment Knob and check that the Wick
moves up and down.
NOTE : DO NOT DISASSEMBLE THE STAINLESS STEEL WICK HOLDER.
Wick
Cover
Hole
Pin