Filter
Top Products
104463-01E
For more information, visit www.desatech.com
For more information, visit www.desatech.com
9
9
INSTALLATION
Continued
Figure 9 - Attaching Stove Legs
Bottom Of
Stove Unit
Leg
Bolt
Figure 10 - Attaching Stove Bottom
Bottom Of
Stove Unit
Bolt
Washers
Stove
Bottom
9. Fasten stove bottom to stove with four (4) M6 x 1 - 25mm bolts.
Use a flat washer and lock washer with each bolt. Tighten bolts
into threaded holes on stove body (see Figure 10 and Figure 8
on page 8). Use an adjustable wrench or a 10mm socket.
10. Attach stove door by inserting step bolt through door hinge
pivot holes and into threaded hole in stove body (see Figure
11). Use an adjustable wrench or a 12mm socket to fasten step
bolt. Tighten step bolt until snug. Make sure door moves freely.
11. Install door catch bolt (M8 x 1.25-55mm with two M8 hex
nuts) into threaded hole on stove body (see Figure 8, page 8).
Use an adjustable wrench or a 12mm socket. The catch bolt
has two hex nuts attached to it (see Figure 12). The top nut is a
bolt stop and the bottom nut is for door leveling adjustment.
12. Check general catch bolt alignment with door claw. Make fi-
nal adjustment and door leveling after stove is in normal stand-
ing position.
13. Carefully lift stove back up on its four attached legs.
14. If available, install gas log heater inside stove cavity before
installing the back panel (see Installing Gas Log Heater Into
Stove, page 10).
15. Fasten back panel to stove with six (6) M6 x 1 - 20mm bolts
and washers. Make sure product identification label is located
on the outside in lower left-hand corner.
Figure 11 - Attaching Stove Door (Appearance May Vary
Depending on Model)
Step
Bolt
Door
Hinge
Threaded
Hole
Stove
Door
Stove Bottom
Bolt
Shoulder
Door
Hinge
Step
Bolt
Bolt
Shoulder
Stove
Door
Adjusting Nut
Bolt Stop
Catch Bolt
Door Claw
Door
Figure 12 - Catch Bolt and Door Claw Orientation
INSTALLATION
Stove Cavity Assembly (Cont.)
INSTALLATION
Stove Cavity Assembly (Cont.)