Filter
Top Products
13
103424
OWNER’S MANUAL
2
4
4
3
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install
these logs exactly as instructed. Do not
modify logs. Only use logs supplied with
heater.
1. Slide rear log (#1) into place behind
rear burner. Make sure flat areas at bot-
tom of log are behind rear burner (see
Figure 16).
2 . Slide bottom middle log (#2) into place
in behind front burner. Make sure tabs
at bottom of log are behind front burner
(see Figure 17).
3. Place front log (#3) into place in front
of bottom middle log (#2) (see Figure
18). Make sure notches on bottom rest
on grate prongs.
4. Finally place top log (#4) over bottom
middle log (#2) by matching the
notches under log (#4) with the raised
blocks of log (#2) (see Figure 19).
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
INSTALLING LOGS
Tab
Figure 17 - Installing Bottom Middle Log
Bottom Middle Log (#2)
Rear Log (#1)
Front Log (#3)
INSTALLATION
Continued
Figure 18 - Installing Front Log
Figure 16 - Installing Rear Log
Figure 19 - Installing Top Log
Top Log (#4)
CAUTION: Do not remove the
metal data plates attached to the
heater base assembly. The data
plates contain important warranty
information.