Filter
Top Products
107124-01E
For more information, visit www.desatech.com
For more information, visit www.desatech.com
15
15
INSTALLATION
Continued
Pin
Hole in
Grate Base
Back Log (#2)
Burner
Figure 24 - Installing Back Log (#2)
Figure 25 - Installing Crossover Log (#3)
2. Locate pins on the bottom of back log (#2). Slide these pins into
the holes in the grate base behind the burner (see Figure 24).
3. Place crossover log (#3) onto the pin (right) on middle log (#1) and
into the recess of the back log (#2). See Figure 25.
4. Locate the notches in the bottom of the front log (#4). Place
the front log on the grate fingers. Make sure the notches of the
front log line up with the grate fingers. See Figure 26.
Front Log (#4)
Grate Fingers
Notches
Figure 26 - Installing Front Log (#4)
Figure 27 - Installing Log Piece (#5)
Pin
Log Piece (#5)
Crossover Log (#3)
Pin
5. With knot to right side, place smaller log piece (#5) over the
pin on the left side of the middle log. The smaller log will rest
on front log against the "knot" on the left. See Figure 27.
6. Place lava rock around base of heater if desired. Do not put
lava rock on logs on burner.
Recess
INSTALLATION
Installing Logs (Cont.)