Filter
Top Products
3
104307
OWNER’S MANUAL
PRODUCT
IDENTIFICATION
Figure 1 - Vent-Free Gas Log Heater (Logs May Vary By Model)
Operation
This heater is clean burning. It requires no
outside venting. There is no heat loss out a
vent or up a chimney. Heat is generated by
realistic dancing, yellow flames. This heater
is designed for vent-free operation with flue
damper closed. State and local codes in
some areas prohibit the use of vent-free
heaters.
Safety Pilot
This heater has a pilot with an Oxygen
Depletion Sensor Shutoff System (ODS).
The ODS/pilot is a required feature for vent-
free room heaters. The ODS/pilot shuts off
the heater if there is not enough fresh air.
Piezo Ignition System
This heater has a piezo ignitor. This system
requires no matches, batteries, or other
sources to light heater.
1. Remove logs and heater base assem-
bly from carton.
Note:
Do not pick up
heater base assembly by burners. This
could damage heater. Always handle
base assembly by grate.
2. Remove all protective packaging ap-
plied to logs and heater for shipment.
3. Check all items for any shipping dam-
age. If damaged, promptly inform
dealer where you bought heater.
UNPACKING
PRODUCT
FEATURES
AUTO
MAN
OFF
STATUS
ONLO
HI
TEMP
Front Log
Control Knob
Back
Log
Base Grate
Burner
Piezo
Ignitor
Crossover Log
Middle Log
Remote
Control
Remote
Selector
Switch
Flame
Adjustment
Knob
LOCAL CODES
Install and use heater with care. Follow all
local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas
Code ANSI Z223, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269