Filter
Top Products
13
105677
OWNER’S MANUAL
AUTO
OFF
ON
3
AUTO
OFF
ON
INSTALLATION
Continued
AUTO
OFF
O
N
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
INSTALLING LOGS
(CGD3924NRA)
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1. Locate pegs on the bottom of back log (#1).
Slide these pegs into the holes in the grate
base behind the burner (see Figure 21).
2. Place the base of the middle log (#2) in
the U-shaped slots of the grate base in
front of the back log. The cutout on the
right of the middle log should fit over the
burner (see Figure 22). Make sure the
front of the middle log is resting on the
tabs of the grate base and the cutout area
is centered over the burner “U” bend.
3. Locate the recesses on the back of the
front log (#3). Fit these recesses between
the posts of the grate base (see Figure 23).
Figure 21 - Installing Back Log (#1)
Figure 22 - Installing Middle Log (#2)
Figure 23 - Installing Front Log (#3)
Peg
Hole in
Grate Base
Back Log (#1)
Burner
Tab
U-Shaped
Slot
Middle Log (#2)
“U” Bend
Front Log (#3)
Recess
Post
Post
Burner
Cutout
Continued
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to HIGH, check to see
if flames contact any log. If so,
reposition logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.
INSTALLING WIRELESS
REMOTE CONTROL
ACCESSORY
Two 9-volt alkaline batteries (not included)
are required to operate this heater with the
wireless hand held remote control set. One
battery must be installed in the receiver and
one in the hand-held remote control unit.
Note:
Only use alkaline batteries.
Installing 9-Volt Battery in
Receiver
1. Locate back of receiver under front
burner of heater.
2. Locate the battery clip mounted on the
back of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Installing 9-Volt Battery (Not
Included) in Hand-Held Remote
Control Unit
1. Remove battery cover on back of re-
mote control unit.
2. Attach terminal wires to the battery.
Place battery into the battery housing.
3. Replace battery cover onto remote con-
trol unit.
Figure 19 - Installing Receiver on the
Back of the Base
Battery Clip
9-Volt Battery
Receiver
Terminal
Wires
Battery Cover
9-Volt
Battery
Terminal
Wires
Figure 20 - Installing Battery in Hand-
Held Remote Control Unit
Remote
Control
Unit
Battery Housing