Filter
Top Products
21
105982
OWNER’S MANUAL
FIREPLACE
INSTALLATION
Continued
Figure 40 - Attaching Alkaline Battery to
Receiver
9-Volt Alkaline
Battery
Receiver
Terminal
Wires
Battery Clip
REMOVING/REPLACING
GLASS DOOR
You must remove glass door to install op-
tional brick liners, logs, lava rock, and em-
ber material.
CAUTION: Do not operate this
fireplace with a broken glass door
panel. Do not operate this fire-
place without the glass door panel
securely in place. For replace-
ment part information see
Re-
placement Parts
, page 30.
Continued
Figure 44- Removing/Replacing Glass Door
1. Open bottom louver and locate the
switch bracket on the left.
2. Unscrew the switch bracket. Lean
bracket forward so you are able to ac-
cess the back of the remote receiver.
3. Locate the battery clip mounted on the
back of the receiver. Slide a 9-volt al-
kaline battery (not included) through
the clip.
4. Attach the terminal wires to the battery.
5. Connect wire leads to TH and THTP to
control valve (see Figure 41).
6. Replace the switch bracket.
Figure 41 - Connecting Remote Accessories
to Control Valve
To Remote
Accessory
Installing 9-Volt Alkaline Battery in
Hand-Held Remote Control Unit
1. Remove battery cover on back of re-
mote control unit.
2. Attach terminal wires to a 9-volt alka-
line battery (not included). Place bat-
tery into the battery housing.
3. Replace battery cover onto remote con-
trol unit.
Figure 42 - Installing Alkaline Battery in
Hand-Held Remote Control Unit
Battery
Cover
9-Volt
Alkaline
Battery
Terminal
Wires
Remote
Control Unit
Battery
Housing
Figure 43 - Removing Top Louver Panel
Top Louver
Panel
1. Remove the upper louver panel by lift-
ing upward and out (see Figure 43).
2. Remove the screws from the three tabs
at the top of the glass door while hold-
ing door securely keeping it from fall-
ing forward.
3. Grasp door by both sides and ease it
upward off of the lower bracket (see
Figure 44).
4. To replace glass door, follow the above
instructions in reverse.
NOTICE: Use only alkaline bat-
teries (not included).
Installing 9-Volt Alkaline Battery
into Receiver
INSTALLING OPTIONAL
WIRELESS HAND-HELD
REMOTE CONTROL
Glass Door
Assembly
Screw
Lower Bracket
for Glass Door
Assembly