Filter
Top Products
107124-01E
For more information, visit www.desatech.com
For more information, visit www.desatech.com
18
INSTALLATION
Installing Logs (Cont.)
Single Burner Seasonal Oak Models
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
The Seasonal Oak Log Set is a reversible log set. This means that the
two bottom logs may be turned to face either direction. The top log,
however, must remain in the same position. Do not modify logs.
Only use logs supplied with heater.
1. Place the back log onto the back of the base assembly. Make
sure log sits forward against the two posts in front of log (see
Figure 36). This log may be turned to face either direction.
2. Place front log onto grate on front of base assembly. The log
will fit down between grate fingers and posts on front of base
assembly (see Figure 37). This log may be turned to face ei-
ther direction.
3. Place the crossover log on top of the back log and front log
making sure pins are inserted into holes on top of logs 1 and 2
(see Figure 38). This log must be placed as shown in Figure 38
or the pins will not seat into holes.
4. Add lava rock around base of heater if desired. Do not put lava
rock on logs or burner.
Figure 36 - Installing Back Log
Figure 37 - Installing Front Log
Front Log
Grate
Fingers
Figure 38 - Installing Crossover Log
Back Log
Post
Post
Post
INSTALLATION
Continued
Base
Assembly
Post
Base
Assembly
Crossover Log
Hole in Back Log
Hole in
Front Log