Desa CCL3018NTA Water Heater User Manual


 
111160-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
16
Single Burner Seasonal Oak Models
CRL2718P/N, CRL2718P/N
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
The Seasonal Oak Log Set is a reversible log set. This means that the
two bottom logs may be turned to face either direction. The top log,
however, must remain in the same position. Do not modify logs.
Only use logs supplied with heater.
1. Place the back log onto the back of the base assembly. Make
sure log sits forward against the two posts in front of log (see
Figure 32). This log may be turned to face either direction.
2. Place front log onto grate on front of base assembly. The log
will fit down between grate fingers and posts on front of base
assembly (see Figure 33, page 17). This log may be turned to
face either direction.
3. Place the crossover log on top of the back log and front log
making sure pins are inserted into holes on top of logs 1 and 2
(see Figure 34, page 17). This log must be placed as shown in
Figure 34 on page 17 or the pins will not seat into holes.
4. Add lava rock around base of heater if desired. Do not put lava
rock on logs or burner.
Figure 32 - Installing Back Log
Back Log
Post
Post
Base
Assembly
INSTALLATION
Continued
7
6
Figure 30 - Installing Crossover Log #6 (CCL3930PTB/NTB
Shown)
Figure 31 - Installing Crossover Log #7 (Model CCL3930PTB/
NTB Only)
Pins
Middle
Log (#2)
Front Log (#1)
Middle
Log (#2)
Crossover
Log (#6)
Holes
Pins
INSTALLATION
Installing Logs (Cont.)
6. Locate holes on the bottom of crossover log (#6). Slide these
holes onto the right pins located in middle log (#2) and front log
(#1). See Figure 30 for CCL3924PTA/NTA or CCL3930PTB/
NTB. See Figure 29, page 15, for CCL3018PA/NA or
CCL3018PTA/NTA.
7.
For CCL3930PTB/NTB only: Locate holes on the bottom of
crossover log (#7). Slide onto the pins located in crossover log
(#6) and middle log (#2). See Figure 31.
8. Add lava rock around base of heater if desired. Do not place
any lava rock on logs or burner.
Crossover
Log (#6)
Crossover
Log (#7)