Filter
Top Products
www.desatech.com
123680-01A
3
Fireplace Installation
1. Fireplace should be fully assembled. See Assembling
Fireplace in replace owner’s manual.
2. Mantel must be installed ush with two walls. Remove
baseboard along walls where mantel is to be installed.
Baseboard will prevent proper installation of mantel and
base.
3. Place mantel base close to installation location. See re-
place owner’s manual for installation clearances. Leave
enough room to insert replace from back of mantel.
4. If installing gas replace, install gas line. See Connecting
to Gas Supply in replace owner’s manual. Remember to
leave access to gas shutoff valve somewhere on mantel
base or where it is accessible to user. Check for leaks. See
Checking Gas Connections in replace owner’s manual.
5. Position replace inside mantel through back opening
(see Figure 6). Carefully position gas lines if applicable.
IMPORTANT: Use caution when positioning replace on
base. Base may scratch easily. Make sure replace is in
proper position within mantel opening before continuing
with installation.
6. Lower bottom louver
door. Use two screws provided in replace hardware kit
and attach replace to wooden base. Close louver door.
Before installing logs
or burner assembly (see owner’s manual) remove screws
securing oor to assembly. Lift oor for access to bot-
tom of replace. Use two screws provided in replace
hardware kit and attach replace base to wooden base.
Reinstall oor with screws removed previously.
Figure 6 - Installing Gas Fireplace
Mantel Top
Assembly
Assembly
Blocks
Assembly
Blocks
1
1
/
4
"
Screws
Mantel
Legs Flush
with Mantel
Base
Figure 5 - Installing Mantel Top
Corner
of Mantel
Legs Must
be Flush
with Edge
of Mantel
Top
IMPORTANT: Align mantel top left to right before installing.
Back corner of mantel leg must be ush with edge of mantel
top before installation.
IMPORTANT: If installing a gas replace, vertical support
will be installed to mantel assembly after gas replace has
been installed. If installing electric replace, rst install verti-
cal support and install replace from front of mantel. Do not
put any weight on mantel top until vertical support has been
installed.