Filter
Top Products
24
105539
DIRECT-VENT FIREPLACE (NATURAL/PROPANE/LP)
®
1
2
3
WARNING: The glass door
must be securely in place before
running this fireplace. Do not run
this fireplace if glass is missing
or broken.
FIREPLACE
INSTALLATION
Continued
Figure 50 - Installing Log No. 1
Figure 51 - Installing Log Assembly No. 2
Figure 52- Installing Log Assembly No. 3
Figure 53 - Placing Ember Material on
Burner
Ember Material
Fireplace Models
DDV37N/P(A, B) and
DDV41N/P(A, B)
1. Place log #1 (back log) on grate. Make
sure the lower middle section of the log
fits securely into the open area in back
of grate (see Figure 50).
2. Place log #2 (two log assembly) onto pins
on left front and middle section of the front
burner (see Figure 51).
3. Place log #3 (crossover assembly) onto
the front right pin on front burner with
the crossover log resting in notch on
back log (see Figure 52).
4. Place lava rock along sides and front of
firebox bottom.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner could cause
performance problems.
It is not necessary to use all of the lava
rock provided.
5. Pull ember material apart into pieces no
larger than a dime. Place these pieces
loosely onto the exposed section of the
front burner and space between logs 2
and 3 where front burner is exposed (see
Figure 53). This will create the glowing
appearance as the flame touches the em-
ber material. Do not block ports by us-
ing too much ember material in one area.
It is not necessary to use all of the em-
ber material provided.
6. Replace the glass door. See Removing/
Replacing Glass Door, page 21.