Filter
Top Products
9
104001
OWNER’S MANUAL
PUMP ROTOR
(Procedure if rotor is binding)
1. Remove upper shell (see page 7).
2. Remove filter end cover screws using
5/16" nut-driver.
3. Remove filter end cover and air filters.
4. Remove pump plate screws using
5/16" nut-driver.
5. Remove pump plate.
6. Remove rotor, insert, and blades.
7. Check for debris in pump. If debris is
found, blow out with compressed air.
8. Install insert and rotor.
9. Check gap on rotor. Adjust to
.076/.101 mm (.003"/.004") if needed
(see Figure 17).
Note:
Rotate rotor one full turn to insure the
gap is .076/.101 mm (.003"/.004") at tight-
est position. Adjust if needed.
10. Install blades, pump plate, air filters,
and filter end cover.
11. Replace fan guard and upper shell.
12. Adjust pump pressure (see page 7).
Note:
If rotor is still binding, proceed as
follows.
13. Perform steps 1 through 6 above.
14. Place fine grade sandpaper (600 grit)
on flat surface. Sand rotor lightly in
“figure 8” motion four times (see Fig-
ure 18).
15. Reinstall insert and rotor.
16. Perform steps 10 through 12 above.
Figure 16 - Rotor Location
100 ROTOR-Domestic PFA/P 059A
Fan Guard
Filter End
Cover
Air Intake
Filter
Pump
Plate
Blade
Air Output
Filter
Rotor
Insert
Sandpaper
Figure 18 - Sanding Rotor
Figure 17 - Gap Adjusting Screw
Locations
Gap Adjusting Screw
Gap Adjusting Screw
.003"/.004"
Gap
Measured
With
Feeler
Gauge
Rotor
Blade
Output Rating
(Btu/Hr.) 150,000
Fuel Use Only Kerosene
or No. 1 Fuel Oil
Fuel Tank Capacity
(Liters/U.S. Gal.) 51/13.5
Fuel Consumption
(Liters/Gal. Per Hr.) 4.1/1.1
Electric Requirements 110V/50Hz
Amperage
(Normal Run)
4.4
Hot Air Output
(CMM/CFM) 14.2/500
Motor RPM 2850
Motor HP 1/4
Approximate Shipping Weight
(KG/Pounds) 31/68
Approximate Heater Weight
without Fuel (KG/Pounds) 26/57
SPECIFICATIONS
Purchase accessories and parts from
your local dealer.
REPLACEMENT
PARTS AND
ACCESSORY
AIR GAUGE KIT - HA1180
Special tool to check pump pressure.