Filter
Top Products
www.desatech.com
113973-01C
5
OPERATING
INSTRUCTIONS
1. Check heater for damage. If heater is damaged,
promptly inform dealer where you bought
heater.
2. Follow all of the safety and operating pre
-
cautions.
3. Check the "O" ring on the POL before each
use. Replace the "O" ring if there is any sign
of wear or damage.
4. Make sure heater regulator knob is in the
"OFF" position.
5. 30,000 Btu Models Only Attach the heater to
the guard on the propane/LP cylinder with the
support arm on the inside of the guard and bolts
through two holes in the guard (see Figure 5).
Tighten the support arm bracket into place us
-
ing the wing nuts provided.
6. For All Models Connect the POL fitting
at regulator to the propane/LP cylinder by
rotating the POL nut counter clockwise into
the propane/LP cylinder's valve outlet and
securely tighten with a wrench.
WARNING: Attach heater in
upright position. Never attach
heater in a horizontal position.
This could lead to dangerous
flare-ups or fire.
7. Securely tighten all gas connections.
8. Open the cylinder's gas valve and check all
connections for leaks. Apply mixture of liquid
soap and water to gas joints. Bubbles forming
show a leak that must be corrected. DO NOT
USE A FLAME.
Figure 5 - Attaching Support Arm and
Regulator to Propane/LP Tank
Regulator
Support
Arm
Bolt
Support Arm
Bracket
Red Button
on Safety
Valve
TO START HEATER
WARNING: When lighting
the heater DO NOT look over
top of heater (reflector). Stand
to the side of the heater during
ignition. Do not stand or have
any part of your body in front
of the heater.
WARNING: MAKE SURE
THERE IS NO OPEN FLAME IN
THE AREA. Fully open the valve
on the propane/LP cylinder.
Read all lighting instructions before attempting
to ignite heater.
1. Turn the heater regulator knob counterclock
-
wise to the "HI" position.
2. Repeatedly push and release the piezo ignitor
(dual burner), or place a lighted match near the
face of the heating element (mesh screen) of the
burner you are lighting, using the hole located
on the side of the reflector. See Figure 6.
CAUTION: Do not light at the
orifice.
3. Depress the red button on the safety valve
admitting gas to the burner (see Figure 6).
WARNING: Do not depress red
valve button before repeatedly
activating the piezo or inserting
match.
Figure 6 - Lighting Heater With a Match