Filter
Top Products
11
OPERATION (cont.)
Operating Modes
Both Classic Plus models operate in 2 modes, FAN Only and COOL.
When in FAN Only mode the unit circulates the surrounding air. When in
COOL mode, the compressor is engaged and cool air is circulated.
■ COOL Mode
Both models will operate in FAN Only mode for approximately 120
seconds before the compressor engages (compressor time delay
program is 120 + 10 seconds).
■ Temperature Control
The room temperature thermistor allows the unit to switch auto-
matically between COOL and FAN Only modes. This is dependent
upon inlet air temperature versus SET POINT temperature.
■ Fan Mode Control DIP Switch
The Fan Mode Control DIP Switch determines whether the FAN will
continue to operate or stop when the compressor cycles off. (SET
POINT temperature equals inlet air or room temperature.) The unit
has been preset at the factory for continuous fan operation.
■ Temperature Scale Display DIP Switch
The Temperature Scale Display DIP Switch changes the SET POINT
temperature that is displayed to either °C or °F. The unit has been
preset from the factory to display the SET POINT temperature in °F.
NOTE: If you wish to change the fan mode operation
(COOLOPERATE to COOLSTOP), and/or the Temperature Scale
Display (°F to °C), contact your MovinCool reseller.