Filter
Top Products
CLEANING AND MAINTENANCE
ODS/PILOT AND BURNER
•Use a vacuum cleaner, pressurized air, or
small, soft bristled brush to clean.
CLEANING BURNER PILOT AIR INLET
The primary air inlet holes allow the proper
amount of air to mix with the gas. This pro-
vides clean burning flame. Keep these holes
clear of dust, dirt, and lint. Clean these air inlet
holes prior to each heating season. Blocked
air holes will create soot. We reccommend
that you clean the unit every three months dur-
ing operation and have heater inspected year-
ly by a qualified service person.
We also reccommend than you keep the burn-
er tube and pilot assembly clean and free of
dust and dirt. To clean these parts we recom-
mend using compressed air no greater than
30 PSI. Your local computer store, hardware
store, or home center may carry composition.
If using compressed air in a can, please follow
the directions on the can. If you don’t follow
directions on the can, you could damage the
pilot assembly.
1. Shut off the unit, including the pilot. Allow
the unit to cool for at least thirty minutes.
2. Inspect burner, pilot for dust and dirt.
3. Blow air through the ports/slots and holes
in the burner.
4. Never insert objects into the pilot tube.
Clean the pilot assembly also. A yellow tip
on the pilot flame indicates dust and dirt in
the pilot assembly (see figure 14). With the
unit off, lightly blow air through the air
inlet. You may blow through a drinking
straw if compressed air is not available.
CABINET
Air passageways
•Use a vacuum cleaner or pressurized air to
clean.
Exterior
• Use a soft cloth dampened with a mild
soap and water mixture.
Wipe the cabinet to remove dust.
14
CAUTION: you must keep control areas,
burner, and circulating air passageways of
heater clean. Do not close this zone. Inspect
these areas of heater before each use. Have
heater inspected yearly by a qualified serv-
ice person. Heater may need more frequent
cleaning due to excessive lint from carpet-
ing, bedding material, pet hair, etc.
WARNING: Turn off heater and let cool
before cleaning
Pilot air inlet
fig. 17
Pilot assembly
WIR 2 26-06-2003 18:21 Pagina 14