Filter
Top Products
5
ELECTRICAL CONNECTION
Before connecting the plug to the power
outlet, make sure that the voltage of your elec-
trical system corresponds to the voltage
shown on the appliance rating label and the
outlet you are going to use is in good condi-
tion.
INSTALLATION
The appliance may be used on any rigid hori-
zontal surface. Do not overload the electrical
circuit; avoid using the same outlet for multi-
ple appliances.
ASSEMBLING THE APPLIANCE
1. Connect the base of the appliance to the
body, inserting the pegs in the seats provi-
ded (see Figure 2).
2. Turn the appliance over and fasten the
base to the body using the screws provi-
ded (see Figure 3).
3. Run the power cord through the opening
provided on the base (see Figure 4).
TOOLS NEEDED AND ESTIMATED TIME
1 Phillips head screwdriver type PH 2 x 100
8 screws (included)
Assembly time: approx. 5 minutes
OPERATION AND USE
1. Connect the appliance to the power outlet.
2. The appliance emits a beep and the power
indicator light (H) comes on and remains
on as long as the appliance is powered.
3. The appliance goes into OFF and the
display shows a dot “
●”. If the dot is
blinking it means that the tip over switch
has been activated. See paragraph:
“Additional safety features” page 7.
4. Press the ON/OFF button (A) to turn on the
appliance. It will begin to heat with the
predefined settings.
5. Press the MODE button (F) to select one
of the following functions available:
Ventilation ( ) Anti-freeze ( )
Heating at minimum power (1) Heating
at maximum power (2)
5.1 Ventilation ( )
In this operating mode only the fan
operates, so the appliance does not
heat the room.
5.2 Anti-freeze ( )
In this operating mode the appliance
keeps the room at a temperature of 45°F
(7°C) to prevent freezing temperatures.
5.3 Heating 1 and Heating 2
In this operating mode you can set the
desired temperature by pressing the +
and - adjustment buttons (B).
Heating 1 (minimum power level):
The appliance operates at the mini-
mum power, reducing noise and
energy consumption to the minimum.
Heating 2 (maximum power level):
The appliance operates at the maxi-
mum power for rapid heating of the
room.
SAVE THESE INSTRUCTIONS
For Household use only
plug periodically for signs of overhea-
ting or deformation. If the outlet has
deteriorated, stop using it and have it
repaired.
21.Check that neither the appliance nor the
power cord have been damaged during
shipping.
22.Make sure that no styrofoam or other
packing materials remain in the applian-
ce.
23.The first time the appliance is used,
run it at the maximum power for at
least two hours. During this time, ven-
tilate the room thoroughly to eliminate
the “new” smell released by the
appliance. It is completely normal for
the appliance to emit “creaking” sounds
the first time it is run.
24.CAUTION: To prevent electric shock,
make sure the wide prong of the plug
is inserted in the wide slot of the
outlet.
25.Do not place the heater near a bed
because objects such as pillows or
blankets can fall off the bed and be
ignited by the heater.
26.Extreme caution is necessary whenever
the heater is left operating unattended.
27.Do not open the appliance. No user-
serviceable parts inside.