Filter
Top Products
5
The instructions below will enable you to prepare your air conditioning unit for operation as effi-
ciently as possible.
Before use, make sure the air intake and outlet grilles are unobstructed.
NON PERMANENT INSTALLATION
Just a few simple steps and your comfort is
ensured with Pinguino:
• Fit the air exhaust hose (12) in the housing (5)
at the back of the appliance. Insert it as
shown in figure A.
In order to improve the performance of the
appliance in air conditioning and boost
(super-conditioning) modes, you can also fit
the intake hose accessory (19) in its housing in
the back of the appliance as shown in figure
A1. This step is optional.
• Fit the window outlets (13)to the end of
the hose (12/19).
• Place the air conditioning unit near a win-
dow or French window.
• Make sure the air exhaust hose is unob-
structed.
Installing your portable
air-conditioner
Keep air hoses as short and free of cur-
ves as possible to avoid constrictions.
ELECTRICAL CONNECTIONS
Before plugging the appliance into the electrical socket, check that:
• the power supply corresponds to the value indicated on the rating plate on the back of the appliance;
• the socket and electrical circuit are adequate for the appliance;
• the socket matches the plug. If this is not the case, have the plug replaced;
• the socket is adequately grounded.
Failure to follow these important safety instructions absolves the manufacturer of all liability.
The power cord must be replaced by a qualified professional only.
1
2
A
A1
Sash window
For optimum results:
• If you have a sash window, place the
bracket (17) or (18)
according to your
needs
, on the window sill, extend the
bracket fully within the window frame, fix the
B1
B
1
3
2
bracket by using the locking pin then lower
the window onto the bracket. Insert the win-
dow outlet (13) of the exhaust hose (12) into
the slot, then connect the hose to the air
conditioner (fig. B and B1).
Thanks to the locking pins, it’s possible to use
the window bracket also for sliding windows.
Position the hole of the bracket so to allow a
correct installation of the exhaust hose.
If the windows are large, use the window bar
without holes (23) (if provided) to cover your
window aperture, extending it to the required
length, then blocking it with the locking pins
supplied (see figure below). Make sure you
do not cover the hole or holes for the window
outlet.