Filter
Top Products
1
3
2
5
PREPARING FOR USE
The instructions below will enable you to prepare your air condi-
tioner for operation as efficiently as possible.
Before use, make sure the air intake and outlet grilles are unob-
structed.
AIR-CONDITIONING WITHOUT INSTALLATION
Just a few simple steps and your comfort is ensured with your
appliance:
• Fit the air exhaust hose (K) in the housing (G) at the back of
the appliance (fig. 1).
• Fit the window outlet (N) to the end of the hose.
• Place the air conditioner near a window or French window.
• Adjust the length of the air exhaust hose to reach the window.
• Make sure the air exhaust hose is unobstructed.
• Open the window or French window slightly and position the
window outlet (fig. 2).
• If you have a double window, use the suction pad (Q) provi-
ded to hold the two parts of the window together (fig. 3).
For optimum results:
• If you have a sash window, place the window bracket (T) on the
window sill, extend the window bracket fully within the window
frame, fix the window bracket by using the locking pin then lower
the window onto the window bracket. Insert the window outlet
(N) of the exhaust hose (K) into the slot, then connect the hose to
the air conditioner (fig. 4).
• Thanks to the locking pins, it’s possible to use the window bracket also
for sliding windows. Position the hole of the window bracket so to
allow a correct installation of the exhaust hose (see figure 5).
• If the windows are large, use the window bracket extension
(U) to cover your window aperture, extending it to the requi-
red length, then blocking it with the locking pins supplied (see
figure 6). Make sure you do not cover the hole for the window
outlet.
Keep the air hose as short and free of curves as possible to avoid
bottlenecks.
1
2
1
2
3
5
1
2
4
6