Filter
Top Products
14
TROUBLESHOOTING
SYMPTOMS
The Pinguino does not
function:
CAUSE
SOLUTION
- power failure
- the appliance is not plugged in
- the notches on TIMER dial
have not been set
- switch is off
- the alarm warning light is on:
the safety float has been
enabled because the collecting
tray inside the unit is too full
- wait
- connect plug
- either push notches out or
disable timer
- turn main switch on
- drain water using the drainage
tube supplied, see page 5.
If problem persist, contact
Service Center
Most malfunctions are caused by a very minor and easily solved problem. Before contacting your
nearest authorized Service Center for assistance, consult the troubleshooting chart below.
The air-conditioner
functions for a brief
period only
- thermostat has been activated
- exhaust hose to outside blocked
- fan blocked
- turn knob anti-clockwise
- remove obstacle
- contact Service Center
The appliance switches
on and off constantly
- switch off and contact Service
Center
The air-conditioner
functions but the room is
not cooled
- window open
- source of heat in room
(heater, lamp, etc.) or room is
overcrowded
- thermostat regulated too high
- air filter clogged
- the capacity of the conditioner
is not adequate for the size of
the room
- close window
- remove heat source
- lower thermostat setting
- clean filter