Filter
Top Products
5
5. OPERATION AND USE
By pressing the “ON/OFF Power selection” button (Fig. 2) one or more times, the appliance will
select the operating heating power (see chart below).
Each time you push the "ON/OFF" button an acoustic signal will be heard.
Note:
It is possible to remove the acoustic signal by pressing the "ON/OFF" button for almost
3 seconds when you plug the appliance in. If you want to restore it, do the same thing.
P max (maximum power)
P med (medium power)
P min (minimum power)
off
If “P max” maximum appliance operating power has been selected, adjust the thermostat dial
(Fig. 2) to the desired comfort temperature, from 42°F ( ) and 95°F (5°C and 35°C).
If the selected temperature is higher than the actual room temperature, the appliance will start
automatically and rapidly heat the room until it reaches the selected temperature. The unit will
automatically mantain the temperature at a constant level, by cycling between “max” (fig. 2),
“med” and “min”, as it approaches the selected comfort temperature.
If the room temperature exceeds the selected temperature level, the appliance will switch off.
The appliance will switch on automatically again when the room temperature falls below the
selected temperature level.
°C °F
542
10 50
15 59
20 68
25 77
30 86
35 95
room temperature
MAX
MAX
MAX
MED
MAX
MIN
MAX
OFF
Selected Power
Power used