Filter
Top Products
Page 8 Page 9
Tower Fan Safety Precautions Using your Tower Fan
Electrical Connection
This appliance should be properly
Ÿ
grounded for your safety. The power
cord of this appliance is equipped with
a three-prong plug which mates with
standard three prong wall outlets to
minimise the possibility of electrical
shock.
Do not under any circumstances cut or
Ÿ
remove the third ground prong from the
power cord supplied. For personal
safety, this appliance must be properly
grounded.
This appliance requires a standard 240
Ÿ
Volt AC ~/50Hz electrical ground outlet
with three-prong. Have the wall outlet
and circuit checked by a qualified
electrician to make sure the outlet is
properly grounded. When a standard
2-prong wall outlet is encountered, it is
your responsibility and obligation to
have it replaced with a properly
grounded 3-prong wall outlet.
Ÿ
Ÿ
Ÿ
The cord should be secured behind the
appliance and not left exposed or
dangling to prevent accidental injury.
The appliance should always be
plugged into its own individual electrical
outlet which has a voltage rating that
matches the rating label on the
appliance. This provides the best
performance and also prevent
overloading house wiring circuits that
could cause a fire hazard from
overheated.
Never unplug the appliance by pulling
the power cord. Always grip the plug
firmly and pull straight out from the
receptacle.
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Repair or replace immediately all power
cords that have become frayed or
otherwise damaged. Do not use a cord
that shows cracks or abrasion damage
along its length or at either end.
When moving the appliance, be careful
not to damage the power cord.
If the supply cord is damaged, it must
be replaced by the manufacturer, its
Service agent or a similarly qualified
person in order to avoid a hazard.
Make sure that the plug is fully inserted
into the wall socket before use.
DO NOT fold or put kinks in the supply
cable or place heavy objects on it. It
could lead to cable damage.
Extension Cord
Because of potential safety hazards
under certain conditions, it is strongly
recommended that you do not use an
extension cord with this appliance.
However, if you must use an extension
cord it must be checked and tested by
a qualified technician or service person.
The extension cord must be a VDE-
Listed, 3-wire grounding extension cord
that has a grounding plug and outlet
and that the electrical rating of the cord
is 220-240 Volts and at least 10
amperes.
Button Function (with LED indicator)Assembly
1. Insert the main body into the base and turn
the base screws clockwise.
2. Screw the cord clamp to fix the cord at the
base.
How to Extract the Remote Control
The remote control can be removed from the
remote control holder located at the top rear
enclosure as shown below.
To replace battery
Note: for initial
use of the
fan, remove
clear plastic
sticker
POWER
To start or stop the fan
On - Green Light
Off - Light Off
WIND
To set normal wind of natural
wind mode
On - Orange
Off - Light Off
TIMER
To set timer level: 2/4/8 hours
2 Hours - Red
4 Hours - Orange
8 Hours - Green
Disable - Light Off
OSCILLATION
To set oscillation angle or stop
oscillation
180 Degree - Green
120 Degree - Orange
60 Degree - Red
Disable - Light Off
SPEED
To adjust the speed level: low /
medium / high
Low Speed - Red
Mid Speed - Orange
High Speed - Green