Filter
Top Products
16
Lighting the burners
WITH ELECTRIC IGNITION (without safety cut-off valve)
mod.
DEGH60WT - DEGH60ST
To light one of the burners, press and turn the corresponding knob to the maximum
flow position (large flame) and keep the knob pressed down until the gas is lit.
Turn the gas tap to the position required.
Whenever lighting any of the burners produces an abnormal flame, switch that burner
off and relight using the minimum setting.
If after relighting the burner, the flame is still abnormal, turn the burner off and contact
our Customer Service Centre to obtain the nearest Authorised Delonghi Service Agent.
Lighting the burners
WITH ELECTRIC IGNITION (fitted with safety cut-off valve)
mod.
DEGH60
In order to light the burner, you must:
1 – Turn the knob in an anti-clockwise direction to the maximum flow position,
push in and hold the knob down which will light the burner.
2 – Wait for about ten seconds after the gas burner has been lit before letting go
of the knob (valve activation delay).
3 – Adjust the gas valve to the desired position.
Important
■ If the burner flame should go out, the safety valve will automatically stop the
gas flow.
■ To re-light the burner, return the knob to the closed position, wait for at
least 1 minute and then repeat the lighting procedure.
■ N.B. If your local gas supply makes it difficult to light the burner with the knob
set to maximum, set the knob to minimum and repeat the operation.
■ Whenever lighting any of the burners produces an abnormal flame, switch that
burner off and relight using the minimum setting.
■ If after relighting the burner, the flame is still abnormal, turn the burner off and
contact our Customer Service Centre to obtain the nearest Authorised Delonghi
Service Agent.