Filter
Top Products
2
IMPORTANT SAFEGUARDS
When using electrical appliances, basic precautions should always be followed to reduce risk of fire,
electric shock, and injury to persons, including the following:
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use handle
when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers,
clothes, and curtains at least 3 feet (0,9 m) from the front and top of the heater and keep them away
from the sides and rear.
3. Extreme caution is necessary when any heater is used by or near children or invalids and whenever
the heater is left operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has
been dropped or damaged in any manner. Return heater to authorized service facility for
examination, electrical or mechanical adjustment, or repair.
6. Do not use outdoors.
7. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never
locate heater where it may fall into a bathtub or other water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange
cord away from traffic area and where it will not be tripped over.
9. To disconnect heater, turn controls to off, then remove plug from outlet.
10. Connect to properly polarized outlets only.
11. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause
an electric shock, fire, or damage the heater.
12. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft
surfaces, like a bed, where openings may become blocked.
13. A heater has hot or arcing or sparking parts inside. Do not use it in areas where gasoline, paint,
or flammable liquids are used or stored.
14. Use this heater only as described in this manual. Any other use not recommended by the
manufacturer may cause fire, electric shock, or injury to persons.
15. To prevent overload and blown fuses, be sure that no other appliance is plugged into the same
outlet (receptacle) or into another outlet (receptacle) wired into the same circuit.
16. It is normal for the heater’s plug and cord to feel warm to the touch. A plug or cord which becomes
hot to the touch or becomes distorted in shape may be a result of a worn electrical outlet (receptacle).
Worn outlets or receptacles should be replaced prior to further use of the heater. Plugging heater
into a worn outlet /receptacle/ may result in overheating of the power cord or fire.