Filter
Top Products
PAGE 3 OF 12
Anti-tilt mechanism
Method 1
All stoves can tilt if you or a child sit or lean on an open oven door.
Safety regulations stipulate that the ANTI-TILT mechanism supplied with the stove,
must be fitted as shown in methods 1 or method 2, depending on the mechanism
supplied with your particular model.
The Anti-tilt bracket kit assembly comprises of:
A 2 x Anti-tilt brackets (stove).
B 2 x Anti-tilt brackets (wall).
C 6 x Securing bolts (4 short and 2 long).
D 4 x Hilti fasteners.
• A is to be fitted at the rear of the stove on the left and right hand side using 2 securing
bolts C in the threaded holes provided.(2 short bolts per side).
• B is fitted to A by the securing bolt C (1 long bolt per side).
• Slightly loosen the securing bolt C to allow B to slide freely over A.
• Position the stove and slide B to touch the wall behind the stove.
• Mark the two holes in B where they touch the wall behind the stove.
• Remove the stove and unfasten the bracket B.
• Using a 6.0 mm concrete bit, drill two holes at the marked positions.
• Using the Hilti fasteners D, firmly secure B to the wall.
• Slide the stove back in position and carefully engage the brackets so that B slides over
A.
• Securely fasten the two brackets by tightening bolt C. (1 long bolt per side).
• The stove is then secured and will not accidentally tilt if downward pressure is applied
to the open oven door.