Filter
Top Products
Dayton Operating Instructions and Parts Manual 3VG81
10
Dayton Propane
Construction Heater
®
41 * #10-32 x 1/4" Screw M12461-25 2
42 * Hex TPG “F” 6-32 s 1/4" Screw M10908-1 2
43 Clip Nut M11271-8 8
44 High Temperature Wire Assembly 101480-10 1
45 High Temperature Wire Assembly 101480-11 1
47 DSI Control No. 2003-19 M51605-02 1
47 DSI Control No. 2003-45 110287-01 1
48 DSI Wire Harness (DSI Control 2003-45 only) 110267-01 1
Wire Assembly (DSI Control 2003-45 only) M9900-170 1
Wiring Decal (DSI Control 2003-45 only) 103402-03 1
Wiring Decal (DSI Control 2003-19 only) 103402-01 1
Service Center List M50985-01 1
Tradename Decal 097940-07 2
General Information Decal 103017-02 1
Thermostat Decal 103021-01 1
Warning Decal 099504-01 2
( ) Not shown.
(*) Standard hardware item, available locally.
Repair Parts List (Continued)
Reference Part No. For
Number Description Model 3VG81 Quantity
LIMITED WARRANTY
DAYTON ONE-YEAR LIMITED WARRANTY. Dayton propane construction gas heater, models covered in this manual are warranted by Dayton Electric Mfg. Co. (Dayton)
to the original user against defects in workmanship or materials under normal use for one year after date of purchase. Any part which is determined to be defective in
material or workmanship and returned to an authorized service location, as Dayton designates, shipping costs prepaid, will be, as the exclusive remedy, repaired or replaced
at Dayton’s option. For limited warranty claim procedures, see PROMPT DISPOSITION below. This limited warranty gives purchasers specific legal rights which vary from
jurisdiction to jurisdiction.
LIMITATION OF LIABILITY. To the extent allowable under applicable law, Dayton’s liability for consequential and incidental damages is expressly disclaimed. Dayton’s
liability in all events is limited to, and shall not exceed, the purchase price paid.
WARRANTY DISCLAIMER. Dayton has made a diligent effort to provide product information and illustrate the product in this literature accurately; however, such
information and illustrations are for the sole purpose of identification, and do not express or imply a warranty that the products are MERCHANTABLE, or FIT FOR A
PARTICULAR PURPOSE, or that the products will necessarily conform to the illustrations or descriptions.
Except as provided below, no warranty or affirmation of fact, expressed or implied, other than as stated in “LIMITED WARRANTY” above is made or authorized by Dayton.
PRODUCT SUITABILITY. Many jurisdictions have codes and regulations governing sales, construction, installation, and/or use of products for certain purposes, which
may vary from those in neighboring areas. While Dayton attempts to assure that its products comply with such codes, it cannot guarantee compliance, and cannot be
responsible for how the product is installed or used. Before purchase and use of a product, review the product applications, and all applicable national and local codes
and regulations, and be sure that the product, installation, and use will comply with them.
Certain aspects of disclaimers are not applicable to consumer products; e.g., (a) some jurisdictions do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not apply to you; (b) also, some jurisdictions do not allow limitations on how long an implied warranty lasts, consequently
the above limitation may not apply to you; and (c) by law, during the period of this Limited Warranty, any implied warranties of implied merchantability or fitness for a
particular purpose applicable to consumer products purchased by consumers, may not be excluded or otherwise disclaimed.
PROMPT DISPOSITION. Dayton will make a good faith effort for prompt correction or other adjustment with respect to any product which proves to be defective within
limited warranty. For any product believed to be defective within limited warranty, first write or call dealer from whom product was purchased. Dealer will give additional
directions. If unable to resolve satisfactorily, write to Dayton at address below, giving dealer’s name, address, date and number of dealer’s invoice, and describing the
nature of the defect. Title and risk of loss pass to buyer on delivery to common carrier. If product was damaged in transit to you, file claim with carrier.
Manufactured for Dayton Electric Mfg. Co., 5959 W. Howard St., Niles, Illinois 60714 U.S.A.
103026-01
Rev. F
10/02
Version B - For Reduction G016.J
®
Manufactured for Dayton Electric Mfg. Co.
Niles, Illinois 60714 U.S.A.