Dansons Group HCS Electric Heater User Manual


 
Copyright 2004 6 Cheap Charlie Owner’s Manual
Canadian Comfort Industries www.dansons.com
Dansons Group Inc.
+
+
8 1/4”
8 3/4”
14 1/4”
3 3/4”
26”
24”
46 1/2”
8 3/4”
24”
31 1/2”
CC EDISON Sr./
CC FRANKLIN 300
CC EDISON Jr. /
CC FRANKLIN 120
Common for
all models
Weight
CC EDISON Sr./
CC FRANKLIN 300
CC EDISON Jr. /
CC FRANKLIN 120
272 lbs.
225 lbs.
Exhaust
Air Inlet
SPECIFICATIONS
HEATING SPECIFICATIONS
- Approx. Heating capacity (Sq Feet) ¹ = 800 – 2,000 sq ft
- Approx. Fuel burn rate per hour ¹¹ = 1.75 – 5.5 lbs per hour
- Hopper Capacity
CC Edison Jr. / CC Franklin120 = 120+ pounds
- Hopper Capacity
CC Edison Sr./ CC Franklin300 = 300+ pounds
¹ Heating capacity will vary depending on floor plan layout of your home, degree of insulation, and the
outside temperature. Fuel size, quality, density and moisture level will also have an effect.
¹¹ Pellet size may affect the actual rate of fuel feed and burn times. Fuel feed rates may vary by as much as
20%. Use PFI listed fuel for best results.
DIMENSIONS
ELECTRICAL SPECIFICATIONS
Electrical Rating = 115 Volts 60 HZ 2.0 Amps
Watts (operational) = 175 (approximately)
Watts (optional igniter) = 475 (approximately)
A voltage surge protector or ground fault outlet is required for this unit. The warranty on the circuit board
will be voided if surge protection is not installed before operating this unit.
FUEL CONSIDERATIONS
Your Cheap Charlie shop and home heater, is designed to burn pellets that comply with Association of Pellet Fuel
Industries standards. (Minimum of 40lbs density per cubic ft, ¼ to 5/16’ diameter length no greater than 1.5”, not
less than 8,200 BTU’s/lb, moisture under 8% by weight, ash under 1% by weight, and salt under 300 parts per
million) Pellets that are soft, contain excessive amounts of loose sawdust, have been or are wet, produce clinkers
and/or heavy ash will result in reduced performance and may actually cause the fire to go out.
(see pelletheat.org for further information)
EPA COMPLIANCE
This heater is exempt from EPA Phase II requirements, but has been tested for emissions using EPA test methods
by Warnock Hersey , US. Pellet appliances that are designed with the combustion air supply exceeding 35:1 (by
ratio) are exempt from EPA regulations.
PRODUCT IS SUBJECT TO CHANGE WITHOUT NOTICE.