Filter
Top Products
37
Hopper Clean-Out Drop Chute
You would have found this along with your Owner’s
Manual, Allen –Key, exhaust gasket and inspection
card. This can have two purposes. The main one
is to be an attachment to the side of the hopper to
help with cleaning out the hopper.
The second purpose would be used as a dust pan
for your shop.
Keep this separate till needed.
Purpose:
Should you find in necessary to remove the pellets from your hopper, for any reason, this handy attachment
will save time and a lot of effort.
Tools Needed:
¼” Hex Nut setter & Driver or Flat Head Screwdriver
Pail or bin
How to Install:
Unplug the appliance power cord from the wall outlet.
To gain access to the inside of the appliance, remove the ¼”
hex screws from the LEFT HAND SIDE PANEL (looking from
the front of the heater). These are located on the back left
hand side corner of the appliance.
Remove the panel simply by sliding it back toward the ex-
haust.
Remove the 2 – ¼” hex screws, labeled A & B.
Install the Hopper Drop Chute, re-installing the screws.
Remove the 5 - ¼” hex screws from the side hopper access
panel. Number 1 – 5 (see picture)
Loosen the #6 screw, but leave it attached. This now allows
the access panel to act as a door.
Place a catch pail under the drop chute.
Raise and lower the access panel as needed.
When finished cleaning out as many pellets as possible, re-
install the 5 screws, remove the drop chute, replace the 2
screws and then install the side panel.
Access
Panel
1
2
3
4
56
A
B
A
A
CCESSORIES
CCESSORIES
Glow Boy Home & Shop Heater www.glowboystoves.com 37