Filter
Top Products
6
1) LED Readout (ROOM HUMIDITY): The
LED window displays the following information
independently:
A) Internal (Room/Environment) Relative
Humidity Conditions
B) Set Operating Relative Humidity Value.
NOTE: The LED readout is programmed to
default to display the ambient relative humidity
conditions.
To view the Set Operating Relative Humidity
Value, press the “up” or “down” button (once)
and the set RH operating value will flash for
approximately 5 seconds in the LED window,
then revert back to display the internal RH
value.
2) ON/OFF Button: Each time this button is
pressed the unit turns ON (adjacent indicator
light illuminates) or Off (adjacent indicator light
is not illuminated)
3) CONTINUOUS: Used for Continuous
Dehumidifier Operation (unit will run non-stop).
NOTE: Humidity values (settings) cannot be
programmed in this mode. The adjacent
(green) indicator light illuminates to signify the
“continous” mode is currently in operation.
4) HUMIDITY UP: This button allows you to
increase the relative humidity setting. Each
time this button is pressed, the RH value set-
ting is increased incrementally by 5% (ranging
from 35% - 80%)
5) HUMIDITY DOWN: This button allows you to
decrease the relative humidity setting. Each
time this button is pressed the RH value setting
is decreased incrementally by 5% (ranging
from 80% - 35%).
6) HIGH FAN: The adjacent (green) indicator
light illuminates when HIGH FAN is selected.
7) LOW FAN: The adjacent (green) indicator
light illuminates when LOW FAN is selected.
8) WATER FULL INDICATOR: This (red) light
illuminates under the following conditions:
A) When the internal water tank is not properly
installed inside the cabinet.
B) When the internal water tank is full. The
water tank must be emptied and replaced back
in the cabinet before normal operating
conditions can resume.
KEY PAD FUNCTIONS
1
2
3
8
6
7
4
5