Filter
Top Products
{
{
4
3
gure 3
Switch
9
Switch
10
Channel
12-volt
DC output
Tune
On On 1 Yes
Classical
O On 2 No
Westminster
On O 3 No
Ding Dong
O O 4 No Whistle
2. Locate the 10 dip switches on the transmitter module (gure 3).
3. The rst eight dip switches are for the frequency setting (256 combinations). Set
switches 1-8 (gure 3-3) to match the eight switches in the receiver.3. Switches 9 and
10 (gure 3-4) are for zone/channel setting on the transmitter. The four zones are
listed below.
Low battery alert: If the receiver sounds a second alert 30 seconds after the rst alert, provided
nothing trips the transmitter again, the 9-volt battery in the transmitter should be changed.
4.