Filter
Top Products
2.
Warnings
This device complies with Part 15 of the FCC rules, Operation of
this device is subject to the following conditions: 1. This device
may not cause harmful interference. 2. This device must accept
any interference, including interference that may cause unde-
sired operation.
Introduction: The IR-3000 is a wireless PIR sensor that is com-
patible with the Dakota Alert 3000 Series of transmitters and
receivers. The IR-3000 is designed for indoor applications or
outdoor applications in a protected area such as under an eve.
When the sensor detects an object it will send a signal to the
receiver which will sound one of four dierent tones (Classical,
Westminster chime, Ding Dong, Whistle.) for a few seconds.
Operation: (Always test unit prior to installation)
1. Connect a 9-volt alkaline battery to the transmitter.
2. Set the dip switches 1-8 on the transmitter module to match
the receiver. (gures 2 & 3)
3. Set dip switches 9 and 10 to control the desired zone, tune,
and relay output. (gures 2 & 3)
4. Mount on wall 6 to 8 feet high slightly pointing down.
Figure 1
PIR with cover opened