Filter
Top Products
10 11
How to stop the Dialer from dialing the telephone numbers in sequence:
When the Auto Dialer starts dialing, it will dial the rst telephone number and repeat the
pre-recorded voice message for 1 minute. If there is no response from the phone, then it
will hang up and dial the next number until all the programmed numbers for that alarm are
dialed. It will repeat this dial sequence three times and display ‘NO ANSWER’ if there is no
response from any of the phone numbers. To stop this dial sequence, press the * key on the
telephone keypad that is receiving the call. At that time, the Auto Dialer will stop its dialing
sequence and the alarm (if programmed) will stop. If the local alarm has been programmed
as active, then pressing the # key will stop the dialing sequence, but the alarm will continue
to sound until timed out. In both cases, the Auto Dialer will remain ON, waiting for any
further alarm.
Quick guide: Answer the phone and press # or * to stop dialing sequence.
How to put the system into PANIC ALARM:
Press both the ON and the OFF buttons on the RF Keyfob at the same time, for 3 seconds.
The dialer will now dial out (Alarm 2) whether the system is armed or disarmed.
CAD-05 Kit Manual.indd 11 10/15/2009 9:40:53 AM