Filter
Top Products
4 5
5. (Note: Tamper switch (Figure 2-4) arms automatically
when depressed and will cause alarm 1 to activate
when released. Disarm by entering password code
1234 into dialer followed by the ESC button or by using
the OFF button on the keyfob). Install the back-up
battery (included) into the dialer. Use a small Phillips
screwdriver to remove screw above battery cover
(Figure 2 - 2). Remove cover by sliding downwards.
Plug in 9V battery making sure not to force onto
battery holder incorrectly. Put 9V battery in space
provided, close battery cover, and replace the screw.
6. The BE+ and BE- terminals (Figure 2-7) are a 12VDC,
150mA (maximum) voltage output which can be used
to power an external bell or whistle when the dialer is
activated.
7. Continue on to the Advanced Operations to program
your dialer or refer to the “AD-01 Quick Reference
Programming” on page 14.
Figure 3
1
2 3
Figure 2
1 7 5 6 4 3 2
AD-01 Kit Manual.indd 5 10/15/2009 10:17:55 AM