Daitsu ASD 9U2 Air Conditioner User Manual


 
ENGLISH
89
Location of the remote controller
Keep the remote controller where its signals can reach the receiver of the indo-
or unit. (a distance of 8m is allowed).
When you select the timer operation, the remote controller automatically trans-
mits a signal to the indoor unit at the specified time.
If you keep the remote controller in a position that hinders proper signal trans-
mission, a time lag of up to 15 minutes may occur.
Replacing batteries
The remote controller uses two alkaline dry batteries (R03/LR03X2)
(1) Slide the cover of the battery compartment, then replace the old batteries with
new ones.
(2) After step (1) is done, push the RESET button.
(3) Before replacing the battery compartment cover, confirm that the display scre-
en on the remote controller displays "0:00" and that the colon is flashing.
After replacing batteries, set the remote controller clock.
HANDLING THE REMOTE CONTROLLER
The air conditioner will not operate if curtains, doors or other materials block
the signals from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose the
remote controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct sunlight,
the air conditioner may not function properly. Use curtains to prevent the
sunlight from falling on the receiver.
If other electrical appliances react to the remote controller. either move these
appliances or consult your local dealer.
CAUTIONS
When replacing batteries, do not use old batteries or different type batteries.
Otherwise it may cause the remote controller to malfunction.
If you do not use the remote controller for a few weeks or more, remove the
batteries. Otherwise, battery leakage may damage the remote controller.
The average battery life during normal use is approximately half a year.
Replace the batteries when there is no receiving beep from the indoor unit
or if the transmission indicator on the remote controller fails to light.
NOTES
06ManualMandoDaitsuEng 21/12/06 16:17 Página 89