Filter
Top Products
18
Installation Instructions
Duct Work Installation
WARNING
During duct installation, make sure there are no
obstructions that keep the damper flaps on the top of the
hood from opening.
Install the duct work starting from the hood, working •
toward the outside vent. Observe the specifications on
page 7.
Fasten all joints with sheet metal screws and seal with •
duct tape or certified silver tape.
Hanging the Range Hood
WARNING
Hanging the range hood requires two people. Do not
attempt to lift the hood without assistance.
Remove the plastic coating from the outside of the 1.
hood.
Remove the filter(s) to reduce weight and avoid dam-2.
age.
Lift the hood up on both sides and slip the mounting 3.
slots over the tabs on the mounting brackets.
Lift the hood into its final position and mark the desired 4.
locations for the anchors or wood screws through the
mounting slots on the back and top of the hood.
Remove the hood from the wall.5.
Drill the pilot or mounting anchor holes. If using mount-6.
ing anchors insert them into the mounting holes.
Reattach the hood to the temporary mounting brackets.7.
Lift the hood into its final position and fasten it in place. 8.
Insert the fasteners through the mounting slots in the
back and top of the hood into the studs, mounting
blocks or anchors.
Mounting Hole Locations