Filter
Top Products
7
Drainage
Plug
Bottom of unit
STORING THE UNIT
1. Unplug the unit from outlet.
2. Remove empty water tanks, filter and cover.
3. Bring base to sink.
4. Drain internal reservoir by tilting unit slightly and removing
the plastic drainage plug from bottom of unit. Plug is tightly
inserted and must be gently, but firmly, worked to remove.
5. When water has completely drained, replace plug, tanks,
filter and cover.
6. Your Cuisinart
Countertop Filtration System is ready to store.
TECHNICAL SPECIFICATIONS
Unit: WCH-1000 1 Cuisinart
®
®
Countertop
Filtration System
1 Cuisinart
®
Water Filter
System Capacity up to 3 months/ 48 gallons/ 181 liters
Maximum Input Temperature 104°F (40°C)
Minimum Input Temperature 34°F (1°C)
Maximum Output Temperature 104°F (40°C)
Minimum Output Temperature 44°F (7°C)
Rated Service Flow 6 gallons / 22.7 liters per day
(may vary according to water conditions)
Electrical Requirements AC~120V 60Hz 1A 75W
See Performance Data Sheet for specific test conditions and results.
Claims are calculated based on WQA accepted practice of average percent reduction. The
contaminants or other substances removed or reduced by this water treatment device are
not necessarily in all users’ water. Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the system. Individuals
requiring water of specific microbiological purity should consult their physician.
The Cuisinart
®
Countertop Filtration System processes approximately 48
gallons/181 liters. When the Cuisinart
®
Water Filter (GF-80) exceeds filtering capacity,
replacement is essential for the product to perform as represented. In the United States,
replacement filters cost generally $19.99 per filter. Replacement filters may be purchased at
most retail outlets. The performance of the filter may vary based on local water conditions.
Hot water should not be used with the Cuisinart
®
Water Filter (GF-80) as it will affect the
filter’s performance.
Refer to the Operating Instructions and Cleaning and Care for general unit operation and
maintenance requirements. Testing was performed under standard laboratory conditions;
actual performance may vary.
System Tested and Certified by WQA against NSF/ANSI Standard 53 for
the reduction of Lead, Benzene, Cadmium, Copper, Mercury,
Tetrachloroethylene, Toluene, and Standard 42 for the reduction of
Chlorine Taste and Odor.