Crown Boiler CLBR68-112 Furnace User Manual


 
4
Notice to the Installer
Installation of this oil-fired furnace must be performed by a qualified installer in accordance
with all local codes and authorities having jurisdiction. In the absence of local governing codes,
installation shall conform to these instructions and to the regulations of the National Fire
Protection Association’s
Standard for the Installation of Oil-Burning Equipment, NFPA 31-
2001, and the National Electrical Code, ANSI/NFPA 70-2002, or the latest editions thereof.
A qualified installer, also referred to in this instruction manual as a “qualified heating
contractor”, is an individual, or agency, properly licensed and experienced to install and
service oil-burning equipment in accordance with all local codes and ordinances.
Material and Workmanship
This furnace was built with the highest quality materials and attention to workmanship.
However, omissions and defects occasionally occur. Before installing the furnace,
inspect the furnace thoroughly. If missing parts, defective material, or poor workmanship
are evident, report the model and serial numbers imprinted on the furnace rating label
to the seller for adjustment.
Packaging
A complete furnace is contained within two (2) packages. The factory completed all
feasible assembly. However certain components including oil burner and draft regulator
and, if supplied, door handle, air filter(s), and air filter rack(s), must be assembled to the
furnace, or the venting system, in the field. Refer to the assembly instructions.
Shipping Damage
If this furnace was damaged during transit, please immediately request the
transportation company inspect the furnace and issue a concealed damage report.
The party receiving the furnace should file the claim for shipping damage. Report any
shipping damage immediately.
It is absolutely essential that a damage report be obtained. If a concealed damage
report is not obtained, we cannot provide assistance in recovering your claim against
the transportation company.
Warranties
c WARNING: The manufacturer of this equipment assumes no liability for any
damages resulting from unauthorized modifications made to the furnace, or any
components thereof, or improper installation of the furnace in the field.
Furthermore, any such field modifications VOID THE WARRANTY and place
responsibility for safe and reliable operation of the furnace on those who
performed the modification(s).
Complete and return any enclosed warranty cards. These must be on file to verify
installation dates for replacement of any warrantied part(s).