Filter
Top Products
Page 6 of 8
Diagram 4.1-3
2. In most cases and as a time saver, connect the camera power at the rear of vehicle
behind the reverse lights. The red power wire line goes to the reverse light + 12 V
and the black wire to ground.
3. Please carefully choose a hidden location to run the camera. Drilling a cable hole
if necessary.
4. Please make sure to use the rubber grommet or plug to make a watertight seal for
the cable where it passes into the vehicle body.
5. Please refer to the monitor wiring diagram. The monitor must be connected using
its own power line and should not be connected to same power line with the
camera.
Step 5: Test Run Your New Rear View Camera System
1. You have just completed the installation and wiring of your new rear view camera
system.
2. Please make sure the vehicle is parked at a safe place before you do a test run.
3. Power up your vehicle and the monitor. Put the vehicle in reverse and the
monitor should immediately display a clear, color picture.
Important: The rear view camera will be used when the vehicle is in reverse gear. If
the monitor does not display a picture or the picture quality not satisfactory, please
double check all cable connections. If you are unable to correct the problem, please
contact your supplier for help.