Crimestopper Security Products SV-6400 Indoor Furnishings User Manual


 
Page 1 of 8
SV-6400 ClipCam
SAFETY PRECAUTIONS
z Make sure to read the Installation Manual” for safety precautions before
installing unit or accessories.
z Please make sure the vehicle is well parked in a safe place. Make sure that the
engine and the power are switched off.
z Avoid installation outdoors during rain or thunder storms.
z The instructions presented in this manual are based on the passenger seat at the
right of the driver’s seat. In an opposite situation, change the directions
accordingly.
z Objects on the monitor are closer than they appear.
z This ClipCam camera is not a safety device. Safe driving is the driver’s
responsibility in all circumstances.
NOTICE-DISCLAIMER
Under no circumstances shall the manufacturer or distributor of the ClipCam be held liable for
consequential or incidental damages sustained in connection with the use of the ClipCam rear vision
system. The ClipCam is designed as a safety enhancement device and is in no way intended as a
replacement for rear-view mirrors, side-view mirrors or physically checking the surroundings when
backing a vehicle. Always check surroundings for safety when backing. Objects on the monitor are closer
than they appear. For the best fit, modification of the vehicle license may or may not be necessary. It is the
sole responsibility of the vehicle owner to check and verify any and all state or federal motor vehicle codes
with regard to modifications of vehicle license plates.
Compilation and Publication Notice
Under the supervision of PEC, this manual has been compiled and published, covering the latest description
and specification. The contents of this manual and the specifications of this product are subject to change
without notice. PEC reserves the right to make changes without notice in the specification and material
contained herein and shall not be responsible for any damages (including consequential) caused by reliance
on the materials presented, including but not limited to typographical and other errors relating to the
publication.