Filter
Top Products
Crestron CLS-EXP-DIMU iLux™ Expansion Module
Setup
Important Notes
Read before installation.
• Permits: An electrical permit shall be obtained
prior to each installation.
• Codes: Install in accordance with all local and
national electrical codes.
• Wiring: Use 75°C copper wire only.
• Not suitable for Hazardous/Classified areas.
Installation
The CLS-EXP-DIMU can be installed vertically on a wall
and can also be installed in a space used for
environmental air as defined in NEC Article 300.22(C).
Refer to the following diagram when installing a
CLS-EXP-DIMU module.
Module Installation
CLS-EXP-DIMU MODULE
MOUNTING SCREW, #8,
QTY 4 TOTAL
(NOT SUPPLIED)
MOUNTING SURFACE
To ensure proper ventilation:
• The device must be installed vertically on a vertical
surface.
NOTE: To prevent potential heat damage to
drywall, do not mount the CLS-EXP-DIMU
directly onto drywall. Mount a piece of ½”
(minimum) thick plywood between the
CLS-EXP-DIMU and the drywall.
• Install device with 6 inches (152 mm) of clearance
from the top and bottom of the device.
Hardware Hookup
WARNING: RISK OF SERIOUS PERSONAL
INJURY. Turn off power at the circuit breaker(s) prior to
installation. Installing with power on can result in serious
personal injury and damage to the device.
1. Use a #2 Philips screwdriver to remove the cover
screws as shown in the following diagram and
remove the cover.
Remove Cover Screws
COVER SCREWS
(x4)
2. Depending on the module’s application, select the
appropriate configuration from one of the wiring
diagrams on the next page and connect the CLS-C6
and load(s) as shown.
• Do not connect wires of differing gauge to a
single terminal.
• Wires should be stripped to 7/16” (11 mm)
• Tighten terminal screws to 7 in-lbs (0.79 Nm)
NOTE: Dimmers controlling one or more
CLS-EXP-DIMU modules must not be wired to
control any other type of load.
NOTE: When using a CLW-Series wall dimmer,
the wall dimmer must be wired with a dedicated
neutral wire.
NOTE: While these diagrams show a CLS-C6 as
the controlling source, other Crestron products
such as CLW-Series wall dimmers (Cresnet
®
and
infiNET™), DIN-1DIMU4, and CLX-Series
dimming modules can be used as well. Please refer
to the specific dimmer’s Installation Guide for
detailed information.
Installation Guide – DOC. 6682B iLux™ Expansion Module: CLS-EXP-DIMU • 5