Filter
Top Products
With a conventional ‘wet’
heating system, when
heating goes off,
building shell cools.
It is smarter to
maintain low level
background heat.
The building shell has
to then be warmed
again before room
feels comfortable.
The room temperature
can be raised quickly
and efficiently when
needed.
This takes time and
energy - slow response.
Economical.
Responsive.
Intelligent.
• Elements (Storage) - 650W incoloy sheathed, mineral
filled elements
• Element (Direct Acting) - cable-on-foil thin facia panel
• Thermostat (Input) - integral electronic charge limiter
Maximum core temperature 670
o
C/690
o
C at full charge
• Thermostat (Output) - integral electronic thermostat with child
lock facility
• Thermal Insulation - Carbowool 128kg/m
2
, Microtherm G
and calcium silicate
• Energy Retention Cells - high density bonded magnetite
• Protection (Storage) - automatic reset core limit thermostat and
manual over-temperature cut out
• Protection (Direct Acting) - automatic reset limit thermostat and
automatic reset over-temperature cut out
• Finish - white polyester and zinc coated steel with grey base
• Cable (Storage) - 1.6m 2.5mm
2
3 core
• Cable (Direct Acting) - 1.6m 0.75mm
2
2 core
• Supply - 230/240V AC single phase
9
Model Height A Width B Depth C Feet Position D
ER300 712mm 600mm 130mm+10mm 295mm
ER400 712mm 830mm 130mm+10mm 523mm
ER500 712mm 1060mm 130mm+10mm 751mm
Minimum clearance required
• 75mm either side of heater
• 150mm in front of the heater
• 250mm directly above the heater
4 zone pilot wire central controller
Allows 7 day programming of comfort/setback time
settings of multiple pilot wire linked heaters in up to
4 separate zones.
Ref: 75 770916
Conventional heater
Dimensions
12 3
12 3
Technical Specification
Eco-Response
+44 (0) 1733 456789 www.creda-heating.co.uk
Eco-Response
Storage radiant heaters
Advanced control
heating systems
Matching TPRIII E
Electronic panel
heaters also available
for pilot wire linked
heating systems
(See page 12-13).
Control options