Filter
Top Products
22 23
INSTALLING METHOD
Be cautious
Installation place
Ⅰ
When installing avoid bumpy areas,
damp areas, and area in the reach of
direct sunlight, dusty areas, water
splashing areas.
■
Installation place
Ⅱ
Have 10Cm space between the wall
and the product and install above the
floor where it is solid and flat.
■
After installation
After installing use after throwing
away room water more than twice.
■
Cold water pipe
Always connect to the cold water pipe.
(When it is connected to hot water pipe the
filter of the Water Filtration System may get
damaged)
■
Moving and installation.
When moved, connect the power
cord after 30minutes of installation.
■
To secure the optimum performance of the product, consult with an
installation expert for further installation. -Service center : 213-480-1600
Residuals may be left inside the filter which is used during the process of
inspection when the product was manufactured.
- It is not used product so feel safe to use them.
Do not use the main water supply valve or hose again that is used before
when installing the product.
Inside water tank
CLEANING METHOD
Press the cold/hot water selection switch
on product front for 2 seconds to turn off,
and close the main water supply valve,
and pull off power cord.
Drain all the water in the storage tank by using the drain hose.
Open the top cover of the product pulling upward and open the sealing clips (6 areas)
of the water tank. Then take out the hose and open the cover of the storage tank.
1
2
3
Installing Method Cleaning Method
Draining out the
cold/room water tank
Draining out the
hot water tank
/
Installation and Cleaning