Filter
Top Products
19
INSTALLING YOUR BIDET
Installing the remote control wall mount
1. Place the remote control wall mount over the required position on
the wall and mark the 2 points for the anchors on the wall.
2. Drill 2 holes with a depth of approximately 35 mm at the marked points.
Use a drill bit with a diameter of ∅ 6.5 mm.
3. Insert the anchors into the holes and push them all the way in.
4. Remove the 2 pieces of protective film from the back of the remote
control wall mount, and attach the mount to the wall aligning the holes
with the anchors in the wall.
5. Place the remote control into the mount as shown by the figure.
Make sure to install the remote control wall mount on the wall using the supplied screws.
Failing to do so may result in the product falling and being damaged.
If the bathroom has 3 sides in a black or similar color, use the remote control while fixing
it to the wall holder.
Failing to do so may result in the product not working properly due to the remote control
signal reception ratio being too low.
Tips
1210964 BA13 사용설명서_수출영문_(09.03.23).indd 19 2009.3.24 10:13:19 AM