Coway BA13-AR Plumbing Product User Manual


  Open as PDF
of 28
 
15
USING YOUR BIDET
Using the rear nozzle
Using the rear nozzle
1. Sit down on the seat and press the ‘Rear Cleansing’ button on the operation part.
2. Self-cleaning for the rear cleansing nozzle is performed, removing the cold water remaining
inside the nozzle before the water stream is ejected so that the water can be set to a desired
temperature for cleansing.
3. The cleansing water is ejected for approximately 1 minute and then stops automatically.
4. Self-cleaning for rear cleansing nozzle is performed for approximately 5 seconds after rear
cleansing. Then the nozzle retracts itself.
5. You can adjust the nozzle position by pressing the ‘Nozzle Position’ button.
6. You can adjust the water ejection angle by pressing the ‘Wide’ button (for the BA13-BR/BE
only).
Moving
Press the ‘Move’ button on the operation part.
-Thenozzlemovesbackandforth,providingawiderrangeofcleansing.
This will operate for as long as the rear cleansing function continues.
You can control the nozzle position by pressing the ‘Nozzle Position’ button.
To stop the move function, press the ‘Move’ button once again.
Drying
Press the ‘Dry’ button on the operation part.
-Warmairisemittedforapproximately2minutes.
If you wipe off the water lightly before turning on the air dryer, drying will finish faster.
You can control the air temperature by pressing the ‘Dry Temp.’ button.
If you press the ‘Dry’ button again during the operation, additional drying starts for another 2 minutes.
If you press the ‘Dry’ button while cleansing, cleansing is stopped and drying starts immediately.
Stopping
To stop the current operation, press the ‘Stop’ button.
-Thisstopsallcurrentlyoperatingfunctions.
The drying function stops 2 seconds after the ‘Stop’ button is pressed.
The cleansing water ejection time may be delayed while the above functions are performed.
Tips
If the ‘Rear Cleansing’ button is pressed again during the cleansing operation, the rear
cleansing function operates for another 1 minute.
While cleansing, users can adjust the water temperature, water pressure, and nozzle
position according to their preferences.
You can not increase the water pressure level higher than level 2 if your area is in the
following conditions.
-Mainwatersupplytemperatureunder10℃andratedpowersourceunder110V~.
If the seat sensor does not detect a human body, the bidet will not work.
Tips
1210964 BA13 사용설명서_수출영문_(09.03.23).indd 15 2009.3.24 10:13:15 AM
 previous next