Coway BA13-AR Plumbing Product User Manual


  Open as PDF
of 28
 
10
CHECK BEFORE USING YOUR PRODUCT
Remove the protective film from the operation part before using it.
Tips
Please keep in mind!
Open the main water supply valve.
The bidet only works normally when water is supplied.
After the installation
Check if water leaks from the main water supply valve or the connecting hose.
YoumustinserttherubberpackingbetweentheT-shapedconnectionpipeandthe
main water supply pipe.
Cleaning the filter on a regular basis
CleantheMESHfilteronaregularbasis(Thecleaningintervalmaydiffer
dependingonthewaterquility).IftheMESHfilteriscontaminatedbyforeign
substances,thefilterisblockedornon-filteredcleansingwatermaybeejected.
If the bidet has not been used for a long time
When the bidet has not been used for a long time, clean the filter and clean each part
ofthebidetsuchastheairdryeroutlet,thenozzleandtheseatbeforeuse(seep.16).
Check whether the product is in eco mode before using it.
-Iftheseatsensordoesnotdetectanyonesittingdownornopanelorremotecontrolbuttonis
pressed for approximately 10 minutes, bidet eco mode is activated, the eco mode indicator
is turned on, and the seat temperature is set to ‘L’ to reduce the power consumption of the
product.
-
When sitting down on the seat or pressing a panel button, the power indicator is turned on, the eco
mode indicator is turned off and the seat temperature returns to the last configured temperature.
-Evenifyousitdownontheseatorpressapanelbutton,thepowerindicatorisnotturned
on. This means that the power is turned off. In this case, press the power selection button to
turn the power on before using it.
Thisproductisfor120V~/60Hzonly.
Make sure to connect the power plug to a grounded electrical outlet
(120V~/60Hz)dedicatedtotheproduct.
Tips
Configure and use a special mode according to your preferences.
Youcanconfigureoneofthespecialmodes(ecomode,seatsensorlockmode,
silentmode)accordingtoyourpreferences(seep.11).
Connect the power.
Plug the power cord into the electrical outlet. The bidet only works normally when
the electricity is connected.
1210964 BA13 사용설명서_수출영문_(09.03.23).indd 10 2009.3.24 10:13:11 AM
 previous next