Filter
Top Products
These instructions do not claim to cover all details or variations in the equipment, procedure, or process described, nor to provide directions for meeting every possible
contingency during installation, operation or maintenance. When additional information is desired to satisfy a problem not covered sufficiently for user’s purpose, please
contact your nearest representative.
Customer First Center • 1121 Hwy 74 South • Peachtree City, GA 30269 IMI-572 AVU040062
Ascent/Strut Fixtures
Sheet 2 of 5
4/26/04 IMI-572
INSTALLATION INSTRUCTIONS
IMPORTANT: READ CAREFULLY BEFORE INSTALLING FIXTURE.
TM
WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing
or servicing.
5. Using WALL PLATE as a template, drill (4) holes in wall. Install
appropriate wall anchors (not supplied) and secure GASKET
and WALL PLATE to wall with (4) 1/2-13 X 1-12 long BOLTS
and (4) Lockwashers (Fig. 5). Torque BOLTS to 450 in/lbs.
NOTE: The SPACER, WALL BRACKET and associated
components and hardware are shipped separately from the
fixture.
6. Assemble WALL BRACKET to SPACER and HOUSING with
(2) BOLTS, (2) FLAT WASHERS, and (2) LOCK WASHERS by
feeding BOLTS through holes in SPACER and into tapped
holes in WALL BRACKET. (Fig. 6A & 6B)
Torque BOLTS as follows:
• (2) 1/2 - 13 (AEM) = 450 in/lbs OR
• (2) 5/16 - 18 (AES) = 130 in/lbs
WARNING
Risk of Personal Injury
Fixture may become damaged and/or
unstable if not installed properly
Tighten all fixture components to their
recommended torque values
WARNING: Risk of Personal Injury. Fixture may become damaged and/or unstable if not installed properly.
Tighten all fixture components to their recommended torque values.
Fig. 6A
BOLTS
LOCK
WASHERS
FLAT
WASHERS
HOUSING
SPACER
WALL
BRACKET
Fig. 6B
SUPPORT
BRACKET
WALL
BRACKET
BOLTS
LOCK
WASHERS
WALL
PLATE
BOX
HOLES
GASKET
Fig. 5